COMP3431 Robotic Software Architecture (UNSW Sydney): rated 2.3/5 overall across 2 reviews collected on UNSW Wall.
COMP3431 is a UNSW Sydney course taught by the Faculty of Engineering in School of Computer Science and Engineering. This page brings together its handbook details and what UNSW students say about it.
Review data updated 2026-10-24.
Chinese title: 机器人软件架构
Type: Undergraduate course
Credit points: 6
Subject area: School of Computer Science and Engineering
Faculty: Faculty of Engineering
Level: Undergraduate Level 3
Handbook year: 2026
An introduction to Intelligent agent design. Picking actions using planning, learning or engineered control.
COMP3431 has 2 scored reviews: overall 2.3/5 (all out of 5; higher difficulty means harder).
Sources: 2 Reddit comments that an AI model judged to be reviewing this course (average would-recommend 2.3/5).
On Reddit: "I have tutored this course previously actually. It was really good when everything was physical since you could come in and interact with the robots themselves, load in new software, check the validity of your simulation and basically understanding how to use ROS (robot operatin…"
On Reddit: "My suggestion is not to take this course, which is very bad. The robot system used in this course is very old and outdated. You basically write programs on your own computer and then remotely control the robot through wifi. You will encounter many equipment problems, such as dif…"
The course panel on UNSW Wall shows every review and discussion in full.
Q: Is COMP3431 worth taking?
A: Averaged over 2 reviews: overall 2.3/5. Only a few reviews so far, so treat this as a rough guide.
Q: Which faculty teaches COMP3431, and when is it offered?
A: COMP3431 is taught by the Faculty of Engineering. Check the official handbook for the current year.
UNSW Wall is an independent student community and is not affiliated with UNSW Sydney.